Car Dents Can Be Easy To Get Out Of Your Car – Here Are Some DIY Tips

Because teeth are an unsightly looking thing. Most of us take pride in the car we own and drive, even if it’s not the most modern compared to the new Mercedes passing in front of you. So it still hurts when someone hits you with a shopping cart, or you get into a minor collision on the road, or even get hit by big hail, which happens from time to time.

Depending on the size of the tooth you just had on your car or just noticed on your car, you may need to visit your local panel beater or body shop to have it checked out. Or, if you’re small enough, you may be able to do this repair yourself with just a few DIY tools.

You will first need to take a good careful look at the damage. If you have ripples or a line or crease in this dent, unless you have some kind of experience with this, you will need to take it to a panel beater so they can access it and calculate a price. . It’s unfortunate if it ends here for what may seem like a fairly small and cheap thing to fix, but even the smallest thing takes time, especially if there’s a crease in the tooth to pull out. However, if you have something simple that has dented your car like a large hailstone, then you can carefully remove it. If it is a whole panel that has taken a beating in a minor traffic accident, then if you are a competent welder, you can buy another panel, remove the dented panel and replace it with a new one.

A helpful tip for crease-free teeth is to use a home plumber’s plunger. You will have to be very careful here. The technique involves applying pressure very, very slowly to the tooth with the plunger over the top, as if you were about to remove a blockage. Therefore, gently but strongly push the plunger down until there is no more air left in the plunger. The best result here is to apply a little water or grease around the rubber edge of the plunger to keep it as airtight as possible. Then, with a very firm grip, pull back on the plunger and it should release the dent. This is hard work and probably impossible to do on corner dents, but it is ideal for side dents, roof dents, and hood and trunk dents on flat panels which, due to the interior trim being difficult to remove They can be repaired quickly and easily.

Another dent repair method is to use a block of wood, an old towel, and a rubber mallet. This is good for teeth larger than the surface area of ​​the plumbers plunger. The towel is to protect the edges of the block of wood. So, wrap the towel around the block and make sure the block doesn’t have a hidden sharp edge, as if it does it’s likely to cause even more damage. This is great for hoods and roofs and boots/trunks. If the dent is in the hood, open the hood and hold the block of clad wood against the bottom of the dent, then tap gently until the dent is gone.